I am redefining the turnout library for Dutch turnouts, because they aren't correcht. For the single and dobule turnouts I managed to get it correctly. The slip starts at the right side of .1 point (aprox 1.225m) with a ratio of 1:100 or 1:200 and sometimes has multiple radii or transitions in it. For the double (and single) slip turnout I try to define the turnout according to the following sketch: The drawing can be horizontally and vertically mirrored. All four sides are the same. I managed to let the slip start on the left side 6,76 behind point .1 (and point .2) and get the ratio of 1:100 and radius R=204 defined in the branches. But I can't define the 1:100 ratio on the right side. Is there a way to get this done? Greetings, Wess Wesselink Designer at Sweco Netherlands
↧
