Tracks Tab (Regression Report Before Using This Command Load a geometry project. Dialog Box Options Left Side Track (Optional) Horizontal is a design centerline. Right Rail is an existing geometry that defines the existing rail, as such these are limited to alignments that are line-strings. Control Track Horizontal is a design centerline. Left Rail is an existing geometry that defines the existing rail, as such these are limited to alignments that are line-strings. Right Rail is an existing geometry that defines the existing rail, as such these are limited to alignments that are line-strings. Include Regression Points specifies that the XML report data file will contain information about the egression points from the Control Track horizontal regression buffer. Interval adds additional points, called computed event points, to the XML report data file. If you provide a value greater than 0.0 in the key-in field, the software computes points along each Selected alignment. On each alignment, the computed points are separated by a distance equal to the specified Interval. The computed points are added to the XML report data file. Limits Station limits the reported information based on the specified Start and Stop station values. The Limits are along the Control Track. When this toggle is not selected, the report covers the entire length of all specified alignments. Note: Limits are useful when you are reporting on a single alignment. Start designates the station at which to begin reporting. This field is used only if the Station parameter is turned on. Stop designates the station at which to end reporting. This field is used only if the Station parameter is turned on. Right Side Track (Optional) Horizontal is a design centerline. Left Rail is an existing geometry that defines the existing rail, as such these are limited to alignments that are line-strings. Several style sheets are included look for the Geometry/SixFoot*.xsl’s. These require that the Left Side and Right Side geometries are both defined (horizontal and rails). A Geometry/Lifts&Lowers.xsl has been included that only uses the data defined in the Control Track group box.
↧