All I am trying to make a template for an island platform to deal with the drainage crossfall. Here is what I have I have two tracks either side of a proposed island platform with a design Horizontal, Vertical and Cant alignment for each I have a template that creates a component for each platform edge/coper, with a point control for each track based on the cant to achieve the correct platform offsets (all OK at this point) Off the back of each coper, I would like to have a 1:80 slope to drain the platform into a channel drain running approximately at the platform centre. I have a component, running from the back of each coper to a point that is constrained by Slope at 1:80 and then Projected to Design, but this is not working. How can I have two end conditions intersect with eachother?
↧
