Dear All I am new to templates design, I think Template is toughest part of this. I have made a Template for 2 tracks having 6.5m centreline to centreline. Ballast 350mm, Subballast/Blanketing 400mm, Subgrade 500mm. I have also showed end conditions for filling and cutting. This is for yards. I have few queries: 1. I am not able to link the components with each other like which component will depend on which.? 2. If my distance between two track centreline changes, then how will it effect. What about cant in curves.What about vertical profile. How will Template actually run after taking care of all these. 3. I have to calculate Quantities for Ballast, Subballast/Blanketing, Subgrade. 4. I know how to link Template with corridor, but unable to link Template with its components. 5. Do i need to use create point control, I only heard, didnt use. 6. I want that Template should run as per the Alignment goes after vertical and cant in curves. 7. After assigning Template to corridor , it is showing some kinks also. Please help for these. Regards Shakun Rana
↧